Máy in 3D

EOS P396

EOS P396 laser sintering system, built 2017, 12,655 laser hours. The machine is operational and located in the Netherlands, available immediately.

It last produced a full validation build in April 2026. Photos and video of that build are available on request, and the parts speak for themselves.

Included in the sale
EOS P396 machine with switchgear cabinet
2x exchangeable build frames
Laser chiller (air/water)
PA2200 Balance material licence
Touchscreen control terminal
Lenovo P3 Ultra workstation, Intel Core Ultra 9, 32 GB, Windows 11, installed 2025

Technical
Process: SLS, polyamide
Laser: 70 W CO2
Build volume: 340 x 340 x 600 mm
Ibodoz A Sycjpfx Anfob
Software: PSW 3.8
Supply: 400 V, three phase

Condition
The original control PC failed in 2025 and was replaced with a new Windows 11 workstation, so the control side of this machine has years left in it. It currently runs a touchscreen; the original EOS console and monitor are in storage and can be supplied instead if you prefer the factory configuration.

The machine has been maintained throughout its life by EOS and by our own technicians. At the last annual EOS service the laser measured 68.1 W on a 70 W laser, with beam alignment and calibration confirmed. Full EOS service documentation is available to serious buyers.

Terms
Sold as-is, where-is, ex works. Buyer arranges rigging, crating, transport and insurance. Payment in full before collection.

Viewing
The machine is in storage and can be viewed by appointment. If you want to see it running, we can recommission it at our facility in Utrecht by arrangement.