Bộ tải thấp

Fliegl ZTS 200 Mähdrescher

Further information
Chassis low loader trailer
Ledpfx Acoi Ri N Aj Dsta
Welded steel construction, with slight pretensioning in the middle, turntable with strong ball bearing slewing ring, wheel chocks with holder, quarter-shell mudguards in front of and behind each axle
Low loader lashing eyes
over front axle:
2 pairs of ring lashing eyes, 5 tons each at the front on offset
Lowbed:
4 pairs of lashing eyes on the side of the low bed, 6 tons each
5 pairs of lashing eyes per 5 tons between the side members
Trailer drawbar Turntable
Drawbar with tested 40 mm drawbar eye, mechanically adjustable in length by 6 x 100 mm and lockable
(drawbar length 1 700 - 2 300 mm)
Axles + suspension
BPW drum brake axles, each with an axle load of 10 tons, axle adjuster. Axle endurance brake test to 105 km/h, rear axle can be removed manually. By releasing the air lock and lowering the rear to the ground. Then disconnect the connecting hoses from the rear section, insert the transport bar into one of the rear sockets and unhook the rear by gently pushing it down at the rear and pulling it back at the same time (parking brake released). After loading or unloading, drive up to the rear section and hook it in up to the mark. Then lift the rear section up to driving height and attach the connecting hoses. Confirm the pin lock. (Visually check whether the bolt engages) and check the rear function.
Air suspension with lift & lower valve
Wheels and tires
235 / 75 R 17.5, from leading manufacturers, steel rims in twin arrangement, factory silver
Brake system
2-line compressed air brake system, spring-loaded parking brake, 2 interchangeable clutch heads at the front, with connecting lines to the motor vehicle, EBS, electronic brake system with EBS plug at the front, with connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side, 2 white position lights at the front, 2 white/red lane departure lights at the rear, rotating beacon with holder, switched via parking light (light can be removed), 2 pairs of warning signs, double LED illuminated and extendable to 3,300 mm, removable with plug, 2 x 7-pin interchangeable plugs at the front, with connecting cable, 1 x 7-pin agricultural plug, voltage converter 12/24 volt (only for electrics, not for ABS/EBS)
Floor
Steel/ checker plate floor on offset, between longitudinal and cross member with perforated plate cover. Axle cover cannot be driven over, widening to 3000 or 3300 mm possible.
Operating instructions
Please note! A special permit is required for axle loads of 10,000 kg. The permit must be applied for individually in each federal state; the legislator does not have to give an approval for 20 tons GG. Customer risk.
Special approval required if the overall length of the train exceeds 18 750 mm. Observe country-specific approval regulations.
The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed.
Observe the BO circle!!!
Approval / plates
Country of registration: Germany, with Dekra approval and expert opinion (according to §13 EG - FGV), prepared for single-line license plate holder, warning sign according to ECE - 70, contour marking with reflective strips according to ECE R 048
Paintwork
Front frame hot-dip galvanized incl. passivation, rear frame RAL9006 silver, drawbar KTL bla

Tin đăng này được dịch tự động. Có thể có lỗi dịch thuật.